====== Click ====== This action allows you to simulate a mouse click (left, middle or right click) at a specific position on the screen. You can simulate a single click (press and release) or a continuous press that can be released in a later action. ===== Standard parameters ===== ==== Input parameters ==== == Action == The action to execute: * Click (press and release) * Press * Release **Warning**: Any unreleased pressed button will be released when the execution ends. == Button == The mouse button to press. //Note//: Only standard buttons can be used. (left, middle or right) == Position == The position where to simulate the click. == Amount == The amount of clicks to simulate. ===== Advanced Parameters ===== ==== Input parameters ==== == Offset == Coordinates, used as a translation vector, applied to the point targeted in the standard parameters. //Example//: if the action is configured to click at //250:110// and if the offset is defined with the value //50:40//, then the action will click at the following coordinates: //300:150//. [//Added in Actionaz 3.6.0.//] ===== Exceptions ===== * [[en:actions:exceptions#Bad parameter|Bad parameter]] * [[en:actions:exceptions#Code error|Code error]] * [[en:actions:exceptions#timeout|Timeout]] * [[en:actions:actionclick#simulation_failed|Simulation failed]] * [[en:actions:actionclick#invalid_action|Invalid action]] ==== Simulation failed ==== This exception is thrown when the simulation failed. * Default action: stop the script execution ==== Invalid action ==== This exception is thrown when the chosen action is invalid. * Default action: stop the script execution ---- Go back to **[[en:actions#devices|list actions]]** Other languages for this page : [[fr:actions:actionclick|(fr)]]