Table of Contents

Click

This action allows you to simulate a mouse click (left, middle or right click) at a specific position on the screen. You can simulate a single click (press and release) or a continuous press that can be released in a later action.

Standard parameters

Input parameters

Action

The action to execute:

Warning: Any unreleased pressed button will be released when the execution ends.

Button

The mouse button to press.

Note: Only standard buttons can be used. (left, middle or right)

Position

The position where to simulate the click.

Amount

The amount of clicks to simulate.

Advanced Parameters

Input parameters

Offset

Coordinates, used as a translation vector, applied to the point targeted in the standard parameters.

Example: if the action is configured to click at 250:110 and if the offset is defined with the value 50:40, then the action will click at the following coordinates: 300:150.

[Added in Actionaz 3.6.0.]

Exceptions

Simulation failed

<BOOKMARK:simulation_failed>

This exception is thrown when the simulation failed.

Invalid action

<BOOKMARK:invalid_action>

This exception is thrown when the chosen action is invalid.


Go back to list actions

Other languages for this page : (fr)